I am ready to pull the IP gear off the shaft. Looking at the center of the gear/shaft from front through oil filler hole......
Seeing a keyway in center of gear which appears to be about twice as high as it is wide. When I look back into the keyway-
it appears that what I THINK might be the key- is just barely taller than the OD of the shaft- is THAT the key ?
It certainly doesn't appear to fill the height of the keyway in the gear if that is it................ would have expected the key
to be much taller.... ?????
Am I looking at the key ????
I want to positively identify it so I don't drop it as the shaft and gear slide apart !
Tim