Moderators: Greenleaf, BC847, Richie O
ellis93 wrote: Poor people have poor ways
ellis93 wrote:It's nothing but a soldering iron but you'll need the plastic "rods" to do it right.
My brother in law body man uses one daily on body panel and is driving a truck with a patched tank right now. We tried to melt it together at first and used black zip tie to "fill in" the gap we made gouging it out. It looked good but cracked out while we were trying to install it. Pulled it back down,waited till we had the rods and tried it again and it held. The plastic in those rods have got to be way different cuase they melted easier and when the crack hardened back up it was really shinny where the rod was melted into it.
Bill....if in a pinch I'd do it for myself,but not for everyone else. Poor people have poor ways
FYI......this has been 1yr plus ago
Users browsing this forum: No registered users and 29 guests