Looking for a runaway vid.
Moderators: Greenleaf, BC847, Richie O
3 posts
• Page 1 of 1
Looking for a runaway vid.
by SuperSix-Two » Wed Dec 30, 2009 2:31 am
It was an old ford pickup with a 6.9L (?) diesel doing a truck pull when the engine runs away. I can't remember how he shut it down, which is why I want to find it again.
1984 W350 Crew Cab Shortbox
-
SuperSix-Two - fuel screw!!!!
- Posts: 38
- Joined: Sun Mar 29, 2009 2:51 pm
by Richie O » Wed Dec 30, 2009 10:01 am
He dumped the clutch. I remember that one too. He was almost out of power then it started really pulling good after it ran away. His was running away on oil I think cause the smoke was heavy.
1989 W250 727, 3.07 L/S, S300, P/S Intercooler, Stans exaust, Pump adjustments, 127k miles,297 hp
1993 W250 extended cab, rag, 4.10 l/s, 6x16's, HTT 62/71/14 piston l/p, Isspro EV series tach, fuel pressure, boost, oil pres, water temp, volt, pryo, 132k/ 301 hp
1992 W250 with NV4500, 3.54's, 16cm 60mm GDS H1C, ground stock cone, Isspro tach, pryo, boost, fuel pressure, slow, rusty, dented,180k
1993 W250 extended cab, rag, 4.10 l/s, 6x16's, HTT 62/71/14 piston l/p, Isspro EV series tach, fuel pressure, boost, oil pres, water temp, volt, pryo, 132k/ 301 hp
1992 W250 with NV4500, 3.54's, 16cm 60mm GDS H1C, ground stock cone, Isspro tach, pryo, boost, fuel pressure, slow, rusty, dented,180k
-
Richie O - Administrator
- Posts: 4171
- Joined: Sat May 17, 2008 9:01 pm
- Location: New England
