tie rod end adjusting sleeve

[jacobwebb57]

anyone know where i can find one of these i was gonna make one but i need the taps..anyone done this or know where i can find a new one

[BILTIT]

junkyard or can buy taps here:

http://www.partsmike.com/store/store.php?crn=226

[Fred_M1010]

Don't they make these sleeves any more?
You could let a company like WFO or ORD make you a complete new tie-rod.
It would be cheaper than buying the taps at least.

[earthdad]

I bought DOM tube 5' , threaded sleeve adapters and jam nuts and it was less expensive than just a tap. All you need is to measure, measure, measure, cut and weld them on. I needed to put new rod ends on and they were literally fused into the tube. I dont think my Dana 60 had adjusting sleeves though. It is just a split end tube with a clamp. Im assuming you got a 60 in front and not a 44.
http://www.ballisticfabrication.com/Ste ... _c_13.html