1stGen.org

THE place for 1st gens

Skip to content

Frame questions

everything but the drivetrain

Moderators: Greenleaf, BC847, Richie O

Post a reply

Frame questions

Postby dazedandconfused » Tue Sep 25, 2012 11:30 am

Does anyone have a 2wd front frame clip without a engine sitting around they could get me a measurement from? I need to know the width of the frame from outside rail to outside rail where the front suspension is mounted. There is to much in the way for me to get a accurate measurement.
Big Andy
1983 Dodge D150 that has been repowered with a 93 Cummins/518 running gear AKA The Ugly Duck! I would much rather build them then buy them.[
User avatar
dazedandconfused
14mm rotor
 
Posts: 6119
Joined: Thu Apr 05, 2007 6:25 pm
Location: Walton, Kentucky
Top

Re: Frame questions

Postby draginmopars » Tue Sep 25, 2012 12:04 pm

29 3/4"
Howard

Ha-Ha Racin
Havin Fun 101
draginmopars
fuel screw!!!!
 
Posts: 86
Joined: Thu Jan 20, 2011 7:53 pm
Top

Re: Frame questions

Postby dazedandconfused » Tue Sep 25, 2012 4:14 pm

Hmmm i was getting 33".
Big Andy
1983 Dodge D150 that has been repowered with a 93 Cummins/518 running gear AKA The Ugly Duck! I would much rather build them then buy them.[
User avatar
dazedandconfused
14mm rotor
 
Posts: 6119
Joined: Thu Apr 05, 2007 6:25 pm
Location: Walton, Kentucky
Top

Re: Frame questions

Postby draginmopars » Tue Sep 25, 2012 5:22 pm

i will take a pic of where i measured to and from
was a 92 club cab/ single rear wheel
Howard

Ha-Ha Racin
Havin Fun 101
draginmopars
fuel screw!!!!
 
Posts: 86
Joined: Thu Jan 20, 2011 7:53 pm
Top
Post a reply

Return to Chassis

Who is online

Users browsing this forum: No registered users and 38 guests

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group