Spindle differences
Moderators: Greenleaf, BC847, Richie O
3 posts
• Page 1 of 1
Spindle differences
by dazedandconfused » Wed Jun 08, 2011 5:21 pm
Does anyone know the difference in the spindles from a D150 to a D250 to a D350? Mark do you know?
Big Andy
1983 Dodge D150 that has been repowered with a 93 Cummins/518 running gear AKA The Ugly Duck! I would much rather build them then buy them.[
1983 Dodge D150 that has been repowered with a 93 Cummins/518 running gear AKA The Ugly Duck! I would much rather build them then buy them.[
-
dazedandconfused - 14mm rotor
- Posts: 6119
- Joined: Thu Apr 05, 2007 6:25 pm
- Location: Walton, Kentucky
Re: Spindle differences
by Mark Nixon » Tue Jun 14, 2011 11:36 am
There are smaller bearings on the D-150.
Careful, there are "light duty" (3300 pound axle) 3/4 ton ones, also.
The giveaway on the "light duty" ones is a 9-1/4 rear axle and a 7500 lb GVW on the door sticker.
Diesel 250/350 (dually, too) spindles interchange.
Mark.
Careful, there are "light duty" (3300 pound axle) 3/4 ton ones, also.
The giveaway on the "light duty" ones is a 9-1/4 rear axle and a 7500 lb GVW on the door sticker.
Diesel 250/350 (dually, too) spindles interchange.
Mark.
- Mark Nixon