Going to check line pressure on a friends truck, and I want to put a small line between the port and gauge. Does anyone know the pipe thread size of the test ports???
Sorry for the newb question, I'm not good at remembering pipe thread sizes.
Pressure port size.
Moderators: Greenleaf, BC847, Richie O
3 posts
• Page 1 of 1
Pressure port size.
by Sutter1stgen » Mon Jun 17, 2013 1:36 pm
Eric
91'w250 with a new pump. This one doesn't chase itself around in a circle.
91'w250 with a new pump. This one doesn't chase itself around in a circle.
- Sutter1stgen
- 14mm rotor
- Posts: 512
- Joined: Wed Sep 12, 2012 8:18 pm
- Location: Northern California.
Re: Pressure port size.
by ellis93 » Mon Jun 17, 2013 1:52 pm
Should be 1/8 pipe
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
-
ellis93 - 14mm rotor
- Posts: 7761
- Joined: Wed Feb 17, 2010 3:16 pm
- Location: lucedale,mississippi