CumminsPower59 wrote:Should be.
Thank You!
Moderators: Greenleaf, KTA, BC847, Richie O
CumminsPower59 wrote:Should be.
RCCUMMINS89 wrote:On a low boost setup that should work just fine, but I wouldn't expect that bend to hold much pressure before blowing out.
RCCUMMINS89 wrote:Because it is a 90 degree elbow of Silicone. Not saying anything bad about the source at all.......but now that you mention it, I had a hard time keeping their boost in their place.
RCCUMMINS89 wrote:For your current setup, just run the silicone 90.
PToombs wrote:I've bought quite a few pieces from Silicone Intakes and had very good luck with them. I'm using an adapter 90* in between my turbos and some straight pieces on the high pressure side, which are seeing 40-50 psi on a constant basis.
PToombs wrote:Looks cool to me! IMO you should put a mesh of some kind on it. It will be a little more background for the black and protect the IC too.
Users browsing this forum: No registered users and 47 guests