i am looking to make a high HP 1st gen and possibly pull with it from time to time. here's what i've done so far.
91w350 5-speed
NV4500 tranny (advanced adapter bellhousing)
SBC Con OFE clutch (i know it's not for pulling but what i could afford for now)
HTT Stage III compressor housing
Pump tweaks
waiting or on the way.
12cm wg housing
Custom 2 stage water meth system
POD's
Here's where i would like some advice from the gurus. I know that the POD's will only take me so far but they were only $200 so i figure i can get that back out of them.
1. What is the best combo for twins? top and bottom?
2. 7mm 1stgen head better? or 2nd gen head?
3. fuel system? recently seems i've read a piston lp alone isn't enough
i'm sure there are more things but remember i am trying to do this on somewhat of a budget and over time as money allows. i was considering trying to build the twins first (bht3b or something on the bottom) and keeping it gated low until i do the head work or at least have it ready to go in what are your reccomendations?