burnt_servo wrote:what about somehow getting the studs to sink deeper into the block ?
You did bottom-tap the stud holes in the block . .. correct?
BC847 wrote:You did bottom-tap the stud holes in the block . .. correct?
seeker1056 wrote:Hey Joel
You get out the drill press- and a good lateral sliding vice and you chuck them babies in and drill 1 1/2" holes n pipe thread em where you have those UGLY holes, , then put sum 1 1/2 x 1 1/2 nipples in them holes and then order yurself a set of 6 valve cover breathers
!!
cummins king wrote:And Bgilbert how do you fix a head gasket with out pulling the head off?
Users browsing this forum: No registered users and 46 guests