Thought I would share what I found. Pretty funny.
http://www.youtube.com/watch?v=t2pGhOWAlaw
.
Funny Ford gasser pulling vid
Moderators: Greenleaf, BC847, Richie O
5 posts
• Page 1 of 1
Funny Ford gasser pulling vid
by Richie O » Wed May 20, 2009 8:06 pm
1989 W250 727, 3.07 L/S, S300, P/S Intercooler, Stans exaust, Pump adjustments, 127k miles,297 hp
1993 W250 extended cab, rag, 4.10 l/s, 6x16's, HTT 62/71/14 piston l/p, Isspro EV series tach, fuel pressure, boost, oil pres, water temp, volt, pryo, 132k/ 301 hp
1992 W250 with NV4500, 3.54's, 16cm 60mm GDS H1C, ground stock cone, Isspro tach, pryo, boost, fuel pressure, slow, rusty, dented,180k
1993 W250 extended cab, rag, 4.10 l/s, 6x16's, HTT 62/71/14 piston l/p, Isspro EV series tach, fuel pressure, boost, oil pres, water temp, volt, pryo, 132k/ 301 hp
1992 W250 with NV4500, 3.54's, 16cm 60mm GDS H1C, ground stock cone, Isspro tach, pryo, boost, fuel pressure, slow, rusty, dented,180k
-
Richie O - Administrator
- Posts: 4171
- Joined: Sat May 17, 2008 9:01 pm
- Location: New England
by pulltilbroke » Wed May 20, 2009 9:22 pm
Saw that a while back, I still laugh every time I see it though
90 W250 reg cab, Modified knuder valve, reversed reciprocting dinglearm adjusted, High volume flux capacitor,upgraded whirlygig, A clutch and a hitch
93 W350 ext cab dually, getrag and a few adjustments
93 W350 ext cab dually, getrag and a few adjustments
- pulltilbroke
- 14mm rotor
- Posts: 1410
- Joined: Fri Jan 18, 2008 1:20 am
- Location: Eagle Ne
