Well I had the engine in and driving once, but in true young hotrodder fashion it wasn't good enough so I pulled it all apart and started over with a new frame. So this is where I'm at so far, more to come in a week or so.
The truck I'm usin', '93 chevy that started life as a 2wd single wheel with the sick.5 diesel and a 5-speed.
Here's what I did for mounts, the bottom tube is 1.5"x3" 7 guage, and the gusset pieces are also 7 guage cut from a chunk of 3"x6" tube. Oh and don't mind the flux residue, the welds are pretty I promise
This is the engine, trans and case full weight on the frame, dead nuts at 5 degrees
That's all for now, garage is tied up again and the cab is at the shop gettin' new rockers and corners.