by ellis93 » Tue Oct 14, 2014 7:07 pm
Dashboard is back in! What a humongous pita too! Between all the wire and the copper tubing,snaking that crap thru the dash was tedious. Had to move the dash pad a little at a time and pull the slack at the same time...under the dash. I almost didn't have enough arm for that
The cluster painting thing worked like a champ,it's at least twice as bright even with the plain Jane bulbs in it. (O'Reilly wanted 20$ for a two pack of LEDs
)
Looks good....to me
I have to wipe everything down now,my woodworking shop is not a very clean place.
Now I have to hook up all the gauges,and rig the cruise up. Then it's play time
Also I was looking on eBay and seen those fuel plates on there for 65$ shipped.
Reckon why there so much cheaper than the others offered on some online venders?
Supposedly they are milled steel that's hardened
Last edited by
ellis93 on Fri Jan 05, 2018 7:16 am, edited 1 time in total.
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz