dana 44 front driveshaft to NP205 Compatible???
Moderators: Greenleaf, BC847, Richie O
3 posts
• Page 1 of 1
dana 44 front driveshaft to NP205 Compatible???
by Collers9640 » Thu Apr 07, 2011 12:32 pm
will a front drive shaft out of a 90 W250 (gas truck) with a dana 44 fit a in my 91 cummins
77’ W200 Cummins- Auto, BHAF, 4” Exhaust
91.5 W250 Cummins Conversion- PS I/C, pump maxed, Red Oak Diesel Injectors, Coolertubz, pump advanced 1/8", 3" elbow, 3200 Spring, Piston Lift Pump, KDP fixed, DennyT pin, HX35, 4in Downpipe, BHAF, Heater Grid Delete, Alcan springs, Bilstein Shocks
1984 D350 Crew Cab (Future Cummins Project)
91.5 W250 Cummins Conversion- PS I/C, pump maxed, Red Oak Diesel Injectors, Coolertubz, pump advanced 1/8", 3" elbow, 3200 Spring, Piston Lift Pump, KDP fixed, DennyT pin, HX35, 4in Downpipe, BHAF, Heater Grid Delete, Alcan springs, Bilstein Shocks
1984 D350 Crew Cab (Future Cummins Project)
- Collers9640
- fuel screw!!!!
- Posts: 172
- Joined: Wed Feb 24, 2010 4:25 pm
- Location: Charleston SC
Re: dana 44 front driveshaft to NP205 Compatible???
by josh_6bt » Tue May 24, 2011 1:09 pm
The CV end should bolt up, however the u-joint at the pinion may be different. Also depending on what trans and t-case are in the gas W250 it could be a different length compared to yours.
1992 W250 EC, 5 speed, 3.54s, 175hp p-pump, timed @ 16.5, #100 fuel plate, 4k GSK, 5x14, .024 DV, head studs, 60lb VS, 4" exhaust, BHAF, cooler tubz.
- josh_6bt
- fuel screw!!!!
- Posts: 55
- Joined: Mon May 16, 2011 6:05 pm
- Location: Regina, Saskatchewan